CAJ Innovations Forums
https://cajinnovations.com/yabb0/YaBB.pl
MyECU >> MyECU Kit Construction >> Lambda connection
https://cajinnovations.com/yabb0/YaBB.pl?num=1411504490

Message started by One Centauro on 09/24/14 at 06:34:50

Title: Lambda connection
Post by One Centauro on 09/24/14 at 06:34:50
Hello . I'm hooking up a Mk5 pcb for lambda connection .
Cliff states that the connection to be made on a 16M is near to the heat sink ....  Is that position marked up as c?17   and the component having 16v and 100 uF on it ? 
TIA   . David.  :)

Title: Re: Lambda connection
Post by YaBB Administrator on 09/24/14 at 06:52:39
There's a 3 pin header next to the comms connector.

The centre is ground, this is not essential as I run a single wire.
You can use either of the two inputs, just make sure the map selects the correct input with the line

# 0 = None, 1 = Inp1, 2 = Inp2, 3 = Both
MyECU Cfg O2Sensors=2

Title: Re: Lambda connection
Post by One Centauro on 09/25/14 at 07:25:25
I knew it was not the centre one   :)   Right , thank you - will ensure your line is included  8-)   .

CAJ Innovations Forums » Powered by YaBB 2.4!
YaBB © 2000-2009. All Rights Reserved.