CAJ Innovations Forums
https://cajinnovations.com/yabb0/YaBB.pl
MyECU >> MyECU Kit Construction >> New here building 16m MKIV
https://cajinnovations.com/yabb0/YaBB.pl?num=1414904731

Message started by Rookedad on 11/02/14 at 16:05:31

Title: New here building 16m MKIV
Post by Rookedad on 11/02/14 at 16:05:31
I have just started building my 16M, that has been on the shelf for about 4 yrs. I have the PCB almost completed.
What do I use for the L2A, is it just a remnant of one of the cut off legs from the other components? I did not find anything in the kit that appeared to match the assembly photos.
Do I attach the MOV to pins 34-35 on the underside after installing the 35 pin connector?
What should I use to attach the connector to the PCB, nuts and bolts, or?

Title: Re: New here building 16m MKIV
Post by sign216 on 11/03/14 at 00:47:25
If I remember correctly, L2A is just a jumper, right?  I used a cut off "leg" from another component.

The 35 pin main connector?  I was building a different unit, but I think it had approx 26 pins.  It was soldered on, and somewhat difficult.

Title: Re: New here building 16m MKIV
Post by Rookedad on 11/05/14 at 03:06:25
Does anyone have a photo to show the location of the MOV on the 16M MKIV? :-/
I have pickup a couple of nylon bolts to attach the 35 pin connector to the PCB before I solder the pins in.

Title: Re: New here building 16m MKIV
Post by YaBB Administrator on 11/05/14 at 06:03:16
The MOV location for the MkIV is the same as for the MKVII - "better to mount directly under main connector between pins 34 and 35"

CAJ Innovations Forums » Powered by YaBB 2.4!
YaBB © 2000-2009. All Rights Reserved.