CAJ Innovations Forums - Harvesting From Old ECUs

12/10/24 at 22:49:18

	Welcome, Guest. Please Login or Register
	Welcome to our forum.

Home

Help

CAJ Innovations Forums › MyECU › MyECU Kit Construction › Harvesting From Old ECUs

(Moderators: YaBB Administrator, _Cliff_)

‹ Previous Topic | Next Topic ›

Pages: 1

Harvesting From Old ECUs (Read 7035 times)

sign216

Full Member

Offline

Posts: 176

Harvesting From Old ECUs
11/21/11 at 00:09:18

I've got an old Ducati 900SS ECU, with the correct square style case with fins, etc (thanks to Ebay!).

Do I lever off the back to get access inside? There's a little sealer, but it shouldn't be hard. However I don't want to start off by breaking things.

Am I right that once open, I de-solder the pin connector and the barometric pressure sensor?
Is that correct?

IP Logged

Rat Patrol

Junior Member

Offline

I love MyECU!

Posts: 53

Re: Harvesting From Old ECUs
Reply #1 - 11/21/11 at 06:05:32

Carefully pry off the sheet metal lid, After that, you can remove the board from the case by unscrewing the four(?) nuts.

Slide the connector/board assembly up out of the case.

Once you've got the board removed you can start to unsolder the connector. That's the tricky part, it helps to have a solder sucker or solder wick. Patience is your friend.

Good luck with it!

IP Logged

sign216 Full Member Offline Posts: 176	Re: Harvesting From Old ECUs Reply #2 - 11/21/11 at 12:14:35 Thanks RP. I suspect desoldering the pin connector will be a test for my skills.
Back to top	IP Logged

YaBB Administrator YaBB Administrator Offline I love YaBB! Posts: 679 The Land of YaBB	Re: Harvesting From Old ECUs Reply #3 - 11/21/11 at 16:17:19 I run a craft knife around the seal first. I have a proper desolder tool and still find it a challenge. I don't know how others manage.
Back to top	The Administrator. IP Logged

Luhbo

Full Member

Offline

I Like My15M!

Posts: 186
Germany

Re: Harvesting From Old ECUs
Reply #4 - 11/22/11 at 18:00:44

By using brute force more or less. The pins are such a tight fit that in nearly all cases the vias were pulled out, too. Next problem might be that if the pins get overheated they will melt loose inside of the connector.
Anyway, a BIG iron, a solder pump, some well sucking wick and one or two screwdrivers normaly do the job.
Hubert

IP Logged

Rat Patrol Junior Member Offline I love MyECU! Posts: 53	Re: Harvesting From Old ECUs Reply #5 - 11/22/11 at 23:05:58 I used a bit more finesse. Went over it once with a solder sucker, then again with wick, then gently pried it away as I heated the remaining stuck pins. Didn't pull any pads, and it came out with no damage. But it's not something I'd like to do for a living! pete
Back to top	IP Logged

sign216 Full Member Offline Posts: 176	Re: Harvesting From Old ECUs Reply #6 - 11/24/11 at 01:28:05 Admin, thanks for the suggestion to use the knife. RatP and Luhbo, I'll use both a desolder pump and wick, although it will still be a chore. Thanks for the tips. Joe
Back to top	IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page