Welcome, Guest. Please Login or Register
MyECU main site
  Welcome to our forum.
  HomeHelpSearchLoginRegister  
 
Pages: 1 2 
Send Topic Print
Fuel Economy (Read 22327 times)
Kiwi Roy
Junior Member
**
Offline


I love MyECU!

Posts: 66
Fuel Economy
04/09/12 at 02:05:33
 
I have a V11 Sport with high compression pistons, it's a real fuel hog.
When I look at the plugs they look ok to me not black but the guys I ride with say it smells rich.
I am a bit afraid to lean out the mixture  incase I overheat something.

What is the best approach

Thanks in advance

Roy
Back to top
 
 
IP Logged
 
raz
Senior Member
****
Offline


Guzzi 11OO Sport, My16MkV,
Innovate LC-1

Posts: 373
Stockholm, Sweden
Gender: male
Re: Fuel Economy
Reply #1 - 04/09/12 at 04:22:06
 
You wont destroy anything just by experimenting. I've been running maps so lean the bike did not run well.

Regarding spark plug color, it mostly just tells you if the idle is lean or rich, unless you turn engine off during load (or cruise), coast to stop and look at the plugs.

raz
Back to top
 

59° North
1100 Sport iniezione elettronica -- the perfect merge of a superbike and a steam train
 
IP Logged
 
YaBB Administrator
YaBB Administrator
*****
Offline


I love YaBB!

Posts: 679
The Land of YaBB
Re: Fuel Economy
Reply #2 - 04/10/12 at 07:03:46
 
I think leanness only damages an engine at high power settings, like an aircraft motor.

You could try a small change like 5% across the entire map  ( maybe leave the bottom left untouched so as not to affect starting and idle )

Your best long term option is to fit a wide band sensor like the LC1 and go closed loop.

Back to top
 

The Administrator.
WWW  
IP Logged
 
Kiwi Roy
Junior Member
**
Offline


I love MyECU!

Posts: 66
Re: Fuel Economy
Reply #3 - 04/10/12 at 13:43:46
 
Thanks Raz, I am still running the map you sent me, the bike runs with stacks of power from low revs all the way to max.
I have removed the stock filter setup and running pods, perhaps that's some of the problem.
Currently I am chewing through 8L/100 km

Thanks Cliff, If I can find where I stowed the laptop I will lean it out as you suggest

Cheers

Roy
Back to top
 
 
IP Logged
 
Luhbo
Full Member
***
Offline


I Like My15M!

Posts: 186
Germany
Re: Fuel Economy
Reply #4 - 04/14/12 at 22:56:51
 
Go back to the OEM configuration (airbox, snorkels, paper filter). I found that any modification of them reduces the airflow. You can tell this from the correction factor the Optimiser shows. Funny enough it's nearly the same with aftermarket cans. They give gains only at higher revs/loads, below the stock ones are unbeatable. It's a pitty they don't look and sound one tenth as good as they perform.
Back to top
 
 
IP Logged
 
Mad Farquhar
Full Member
***
Offline


Slainthe mhath

Posts: 171
Black Isle, Scotland
Gender: male
Re: Fuel Economy
Reply #5 - 04/15/12 at 02:22:07
 
I believe Raz found out that "pods" instead of original airbox was poorer in operation on his 1100 Sporti. I am running K&Ns on the 1100 sporti TBs and am interested in these findings. The airbox was removed as that is where I put the optimiser card as I incorporated the buttons and lcd in a purpose made instrument housing so I would need to rearrange that if I went back to original.
Back to top
« Last Edit: 04/15/12 at 02:46:38 by Mad Farquhar »  

MG Sport 1100 inj
Triking
Honda ST1100
V7 Stone
...
 
IP Logged
 
Luhbo
Full Member
***
Offline


I Like My15M!

Posts: 186
Germany
Re: Fuel Economy
Reply #6 - 04/16/12 at 05:10:39
 
Luhbo wrote on 04/14/12 at 22:56:51:
.... reduces the airflow....


Not around bike and driver but through the engine Wink

Hubert
Back to top
 
 
IP Logged
 
raz
Senior Member
****
Offline


Guzzi 11OO Sport, My16MkV,
Innovate LC-1

Posts: 373
Stockholm, Sweden
Gender: male
Re: Fuel Economy
Reply #7 - 04/18/12 at 02:37:30
 
Yeah, like Luhbo I could clearly see the Optimiser saying 5-10% less fuel could be used in most modes of operation. So despite the better looks of the pods I ditched them and went back to original box with some extra holes in the lid a la Phil Arnold. BTW Phil also confirmed the same thing - on a dyno.

Raz
Back to top
 

59° North
1100 Sport iniezione elettronica -- the perfect merge of a superbike and a steam train
 
IP Logged
 
Kiwi Roy
Junior Member
**
Offline


I love MyECU!

Posts: 66
Re: Fuel Economy
Reply #8 - 04/19/12 at 20:44:28
 
My experience with pods, I seemed to get a flat spot in mid rev range.
I figured the rubber tubes that connect the throttle bodies to the airbox were acting as a tuned intake so I mounted the pods in the end of those. sure enough the power came right back.

The K&Ns slipped inside and I fastened them in with a couple of self tappers.
Back to top
 
 
IP Logged
 
Mad Farquhar
Full Member
***
Offline


Slainthe mhath

Posts: 171
Black Isle, Scotland
Gender: male
Re: Fuel Economy
Reply #9 - 04/20/12 at 06:57:29
 
Kiwi Roy wrote on 04/19/12 at 20:44:28:
I figured the rubber tubes that connect the throttle bodies to the airbox were acting as a tuned intake so I mounted the pods in the end of those. sure enough the power came right back.
 

Interesting.
Back to top
 

MG Sport 1100 inj
Triking
Honda ST1100
V7 Stone
...
 
IP Logged
 
sign216
Full Member
***
Offline



Posts: 176
Re: Fuel Economy
Reply #10 - 04/20/12 at 07:05:02
 
Mad Farquhar wrote on 04/20/12 at 06:57:29:
Kiwi Roy wrote on 04/19/12 at 20:44:28:
I figured the rubber tubes that connect the throttle bodies to the airbox were acting as a tuned intake so I mounted the pods in the end of those. sure enough the power came right back.
 

Interesting.


Yes, you would think that the different characteristics of the pod filters would negate any intake tract tuning.  Good to see.

I'm a smallblock rider, and one of the good traits of the new 2012 engine is that it appears Guzzi may have resonance tuned the intake.  A first for the modern smallblocks.
Back to top
 
 
IP Logged
 
Kiwi Roy
Junior Member
**
Offline


I love MyECU!

Posts: 66
Re: Fuel Economy
Reply #11 - 04/20/12 at 21:08:42
 
Velocity Stack, thats the term I was grasping for.
http://en.wikipedia.org/wiki/Velocity_stack

I find it interesting how the maps of a bike run in closed loop swell in mid rev range then taper off again.
Heres one of Cliff's for example


InjDur 08  3984  7968  7872  7712  7632  7456  7280  6768  6416  5856  5856  5312  4960  4784  4736  4160

I reckon in theory at a given throttle opening since the injectors operate in choked flow mode (flow rate is constant) opening time equates to fuel flow.
Having said that I would expect the injector time to be quite flat however in mid range because of the "Velocity Stack" effect much more air crams into the cylinder therefore more fuel is required to keep the air fuel ratio constant.

I'm willing to bet if you ran the same engine without the intake connected the shape would be much flatter.

Ok, tell me I'm out to lunch  Smiley
Back to top
« Last Edit: 04/20/12 at 21:16:31 by Kiwi Roy »  
 
IP Logged
 
YaBB Administrator
YaBB Administrator
*****
Offline


I love YaBB!

Posts: 679
The Land of YaBB
Re: Fuel Economy
Reply #12 - 04/22/12 at 16:00:18
 
Your example doesn't show a swelling at midrange and then a taper. Ignoring the first entry which is purely to help clear a flooded engine when starting, the numbers generally decrease with rpm.
The reason for this is that the fuel must match the air going into the engine. The airflow is really controlled by  the restrictive intake tract - filter, throttle, etc. The engine can't really suck more in at higher rpm.
Hence as rpm increases the engine gets less air per stroke.
Back to top
 

The Administrator.
WWW  
IP Logged
 
Kiwi Roy
Junior Member
**
Offline


I love MyECU!

Posts: 66
Re: Fuel Economy
Reply #13 - 04/25/12 at 21:01:32
 
So much for that theory then  Huh

I will have to find another theory to explain how adding some length to the intake tract seems to improve the power band and why the stock airbox works best.

Thanks for the explanation Cliff, it makes perfect sense.
Back to top
« Last Edit: 04/25/12 at 21:14:11 by Kiwi Roy »  
 
IP Logged
 
YaBB Administrator
YaBB Administrator
*****
Offline


I love YaBB!

Posts: 679
The Land of YaBB
Re: Fuel Economy
Reply #14 - 04/26/12 at 07:42:32
 
My explanation ignored any affects of resonances in inlet or exhaust which will cause peaks and troughs on top of what I mentioned.
Back to top
 

The Administrator.
WWW  
IP Logged
 
Pages: 1 2 
Send Topic Print