Hi,
I have a big problem with my MG 1100 Sport(1997, 120000 kms, open loop) The engine has stopped  on the road. And since, I can't start the engine . The battery is fully loaded, the injectors give fuel, the sparks are Ok. Air and oil sensor are OK too. If I run the starter for about 5 or 6 secondes, the engine starts (not at each time) very slowly during about 3 second and stops. If during these 3 secondes I turn the throttle for a very small angle or for a large angle the engine stops too.
I have try with several maps, with just modifying the open loop: same thing...
I have does a dump but It is difficult to load it with ecuControl (1.45).
I can see debug messages
engine not started (with 3 actions on throttle)
d0B0104000000451D7C3D1F003F
d0B0108000000D52C4EAC0A000E
engine started slowly
d0B0108000000F81A4E3D0D00B3
d0B01040000008914E4C114005B
Have you an idea?
thanks
alain

hi,
I have checked the injectors command with a  LED, it's ok on injector connectors. I have verified the value of phase sensor at the sensor connector and at ecu connector : same value , 720 ohms. Today, engine starts easily at idle, it's ok for about 30 seconds. but it stops if i turn the throttle.
I don't understand the values read for the throttle
  - between pin 5 and gnd: 460 ohms .
  - between pin 6 and gnd: idle 1.2 Ko, Max 2 Ko
  - between pin 5 and 6: idle 1.6 Ko, Max 2.6 Ko
how can i send you the map used and debug files.
thanks
alain