12/10/24 at 06:41:32
  
  Welcome, Guest. Please Login or Register
 MyECU main site
  Welcome to our forum.
 
  HomeHelpSearchLoginRegister  
 
  CAJ Innovations Forums › MyECU › MyECU Kit Construction › Lambda connection
(Moderators: YaBB Administrator, _Cliff_)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1
Send Topic Print
Lambda connection (Read 3823 times)
One Centauro
YaBB Newbies
*
Offline


I Love YaBB 2!

Posts: 20
Lambda connection
09/24/14 at 06:34:50  
Hello . I'm hooking up a Mk5 pcb for lambda connection .
Cliff states that the connection to be made on a 16M is near to the heat sink ....  Is that position marked up as c?17   and the component having 16v and 100 uF on it ? 
TIA   . David.  Smiley
Back to top
 
 
IP Logged
 
YaBB Administrator
YaBB Administrator
*****
Offline


I love YaBB!

Posts: 679
The Land of YaBB
Re: Lambda connection
Reply #1 - 09/24/14 at 06:52:39  
There's a 3 pin header next to the comms connector.

The centre is ground, this is not essential as I run a single wire.
You can use either of the two inputs, just make sure the map selects the correct input with the line

# 0 = None, 1 = Inp1, 2 = Inp2, 3 = Both
MyECU Cfg O2Sensors=2
Back to top
 
The Administrator.
WWW  
IP Logged
 
One Centauro
YaBB Newbies
*
Offline


I Love YaBB 2!

Posts: 20
Re: Lambda connection
Reply #2 - 09/25/14 at 07:25:25  
I knew it was not the centre one   Smiley   Right , thank you - will ensure your line is included  Cool   .
Back to top
 
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print
‹ Previous Topic | Next Topic ›
  « Home ‹ Board Top of this page

CAJ Innovations Forums » Powered by YaBB 2.4!
YaBB © 2000-2009. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge