CAJ Innovations Forums - New here building 16m MKIV

12/10/24 at 06:20:05

	Welcome, Guest. Please Login or Register
	Welcome to our forum.

Home

Help

CAJ Innovations Forums › MyECU › MyECU Kit Construction › New here building 16m MKIV

(Moderators: YaBB Administrator, _Cliff_)

‹ Previous Topic | Next Topic ›

Pages: 1

New here building 16m MKIV (Read 4297 times)

Rookedad

YaBB Newbies

Offline

I love MyECU!

Posts: 2

New here building 16m MKIV
11/02/14 at 16:05:31

I have just started building my 16M, that has been on the shelf for about 4 yrs. I have the PCB almost completed.
What do I use for the L2A, is it just a remnant of one of the cut off legs from the other components? I did not find anything in the kit that appeared to match the assembly photos.
Do I attach the MOV to pins 34-35 on the underside after installing the 35 pin connector?
What should I use to attach the connector to the PCB, nuts and bolts, or?

IP Logged

sign216 Full Member Offline Posts: 176	Re: New here building 16m MKIV Reply #1 - 11/03/14 at 00:47:25 If I remember correctly, L2A is just a jumper, right? I used a cut off "leg" from another component. The 35 pin main connector? I was building a different unit, but I think it had approx 26 pins. It was soldered on, and somewhat difficult.
Back to top	IP Logged

Rookedad YaBB Newbies Offline I love MyECU! Posts: 2	Re: New here building 16m MKIV Reply #2 - 11/05/14 at 03:06:25 Does anyone have a photo to show the location of the MOV on the 16M MKIV? I have pickup a couple of nylon bolts to attach the 35 pin connector to the PCB before I solder the pins in.
Back to top	IP Logged

YaBB Administrator YaBB Administrator Offline I love YaBB! Posts: 679 The Land of YaBB	Re: New here building 16m MKIV Reply #3 - 11/05/14 at 06:03:16 The MOV location for the MkIV is the same as for the MKVII - "better to mount directly under main connector between pins 34 and 35"
Back to top	The Administrator. IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page