Welcome, Guest. Please Login or Register
MyECU main site
  Welcome to our forum.
  HomeHelpSearchLoginRegister  
 
Page Index Toggle Pages: 1
Send Topic Print
New here building 16m MKIV (Read 4298 times)
Rookedad
YaBB Newbies
*
Offline


I love MyECU!

Posts: 2
New here building 16m MKIV
11/02/14 at 16:05:31
 
I have just started building my 16M, that has been on the shelf for about 4 yrs. I have the PCB almost completed.
What do I use for the L2A, is it just a remnant of one of the cut off legs from the other components? I did not find anything in the kit that appeared to match the assembly photos.
Do I attach the MOV to pins 34-35 on the underside after installing the 35 pin connector?
What should I use to attach the connector to the PCB, nuts and bolts, or?
Back to top
 
 
IP Logged
 
sign216
Full Member
***
Offline



Posts: 176
Re: New here building 16m MKIV
Reply #1 - 11/03/14 at 00:47:25
 
If I remember correctly, L2A is just a jumper, right?  I used a cut off "leg" from another component.

The 35 pin main connector?  I was building a different unit, but I think it had approx 26 pins.  It was soldered on, and somewhat difficult.
Back to top
 
 
IP Logged
 
Rookedad
YaBB Newbies
*
Offline


I love MyECU!

Posts: 2
Re: New here building 16m MKIV
Reply #2 - 11/05/14 at 03:06:25
 
Does anyone have a photo to show the location of the MOV on the 16M MKIV? Undecided
I have pickup a couple of nylon bolts to attach the 35 pin connector to the PCB before I solder the pins in.
Back to top
 
 
IP Logged
 
YaBB Administrator
YaBB Administrator
*****
Offline


I love YaBB!

Posts: 679
The Land of YaBB
Re: New here building 16m MKIV
Reply #3 - 11/05/14 at 06:03:16
 
The MOV location for the MkIV is the same as for the MKVII - "better to mount directly under main connector between pins 34 and 35"
Back to top
 

The Administrator.
WWW  
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print